Orliice Mechanics

SETTINGS

Charging voltage : 5V…

Operating current : 0.12A

Rated power : 0.6W

Applicable standard : GB 4706.1-2005

Instructions

1. This product is worn around the neck, with the collar close to the body, with the front located below the collarbone.

2. Make sure the main sensor is vertical and in good contact with the body.

3. This product must be in contact with the skin and worn under clothing, otherwise the measurements may be inaccurate and the device may fall off.

Settings

1. Switching on and off

• Power on : Press and hold for 2 seconds

• Power off : press and hold for 2 seconds

2. Adjustment method

Adjust the appropriate correction angle, hold the power button for 2 seconds, then the device displays two “88” flashing three times, then displays two “88”, indicating that the product is working normally (Figure 1).

3. Posture reminder

In case of excessive curvature of the back or shoulders, the device vibrates continuously if the angle exceeds 25 degrees, until the posture is corrected.

Each vibration is recorded, and the device stops vibrating when the angle returns to between 5 and 0 degrees (Figure 2).

Reminder and description of the indicators

1. It is recommended to fully charge the device before first use.

2. After a long period of use, if the vibration becomes weak, it is advisable to recharge it quickly.

3. This product is recommended for children over 4 years old, adolescents and adults.

4. This product should be worn against the skin and under clothing to avoid inaccurate recalls, falls or other problems.

Recycling ♻️

1. When the device reaches the end of its life, the internal battery may need to be removed in accordance with local laws and regulations. If the battery cannot be removed, please take the product to an approved recycling center.

2. Do not disassemble the product yourself, except for disposal. Premature disassembly may damage the product. Before removing the battery, it is imperative to disconnect the power supply.

3. Before removing the battery, make sure it is completely discharged. If necessary, leave the device on until it turns off automatically.

4. For proper recycling or disposal of batteries, please consult your local government approved recycling center.

5. Avoid short-circuiting the positive and negative poles of the battery. After removing the battery, the device must not be turned on again.

Care Instructions

The product can be returned for maintenance. However, the following cases are not covered by the warranty:

1. The warranty period has expired.

2. Damage caused by improper use or accidents (dropping, immersion in water, power surge, etc.).

3. Failures or damages due to natural disasters or force majeure (earthquakes, fires, lightning, etc.).

4. Normal wear and tear of the product due to regular use.

Cleaning and storage

1. The main sensor of this product is not waterproof. Do not rinse it with water. Clean it with a dry or slightly damp cloth.

2. The collar can be washed separately or wiped with a damp cloth. Let it dry in the shade after washing, avoid direct sunlight.

3. If using volatile substances such as alcohol to clean or disinfect, place the device in a cool, well-ventilated area until completely evaporated.

4. Storage conditions :

• Temperature: -10°C ~ +50°C

• Relative humidity: 10% - 80% (non-condensing).

5. If the product is not used for a long time, recharge the sensor regularly to avoid deterioration.

6. Store in a well-ventilated place, free from corrosive gases, away from direct sunlight, heat sources and open flames.